CertBus 2018 Real Cisco 400-101 CCIE Exam VCE and PDF Dumps for Free Download!
☆ 400-101 CCIE Exam PDF and VCE Dumps : 1379QAs Instant Download: https://www.certgod.com/400-101.html [100% 400-101 Exam Pass Guaranteed or Money Refund!!]
☆ Free view online pdf on CertBus free test 400-101 PDF: https://www.certgod.com/online-pdf/400-101.pdf
☆ CertBus 2018 Real 400-101 CCIE exam Question PDF Free Download from Google Drive Share: https://drive.google.com/file/d/0B_3QX8HGRR1mdEpkTFZvSDJDc2c/view?usp=sharing
Following 400-101 1379QAs are all new published by Cisco Official Exam Center
CertBus has the latest update version of Cisco CCIE Jul 03,2018 Hotest 400-101 exam questions exam, which is a hot exam of Cisco CCIE certification. CertBus Cisco CCIE exam dumps will fill you with confidence to pass this certification exam with a satisfied high score.
as a leading 400-101 exam study guides provider, CertBus provides the latest real test practice for hottest cisco, microsoft, comptia, vmware, ibm, hp, oracle, citrix exams. 100% real and latest. CertBus latest 400-101 test questions and answers. 100% high quality and accuracy. CertBus – 400-101 certification with money back assurance.
We CertBus has our own expert team. They selected and published the latest 400-101 preparation materials from Cisco Official Exam-Center: https://www.certgod.com/400-101.html
Which two commands are required to enable multicast on a router, knowing that the receivers only
support IGMPv2? (Choose two.)
A. ip pim rp-address
B. ip pim ssm
C. ip pim sparse-mode
D. ip pim passive
Sparse mode logic (pull mode) is the opposite of Dense mode logic (push mode), in Dense mode
it is supposed that in every network there is someone who is requesting the multicast traffic so
PIM-DM routers begin by flooding the multicast traffic out of all their interfaces except those from
where a prune message is received to eliminate the
A branch router is configured with an egress QoS policy that was designed for a total number of
10 concurrent VOIP calls.
Due to expansion, 15 VOIP calls are now running over the link, but after the 14th call was
established, all calls were affected and the voice quality was dramatically degraded.
Assuming that there is enough bandwidth on the link for all of this traffic, which part of the QoS
configuration should be updated due to the new traffic profile?
A. Increase the shaping rate for the priority queue. B.
Remove the policer applied on the priority queue. C.
Remove the shaper applied on the priority queue. D.
Increase the policing rate for the priority queue.
Which two options are contained in a VTP subset advertisement? (Choose two.)
A. followers field
B. MD5 digest
C. VLAN information
D. sequence number
When you add, delete, or change a VLAN in a Catalyst, the server Catalyst where the changes are
made increments the configuration revision and issues a summary advertisement. One or several
subset advertisements follow the summary advertisement. A subset advertisement contains a list
of VLAN information.
If there are several VLANs, more than one subset advertisement can be required in order to
advertise all the VLANs.
Subset Advertisement Packet Format
This formatted example shows that each VLAN information field contains information for a different
VLAN. It is ordered so that lowered-valued ISL VLAN IDs occur first:
Most of the fields in this packet are easy to understand. These are two clarifications:
Which three options are features of VTP version 3? (Choose three.)
A. VTPv3 supports 8K VLANs.
B. VTPv3 supports private VLAN mapping.
C. VTPv3 allows for domain discovery.
D. VTPv3 uses a primary server concept to avoid configuration revision issues.
E. VTPv3 is not compatible with VTPv1 or VTPv2.
F. VTPv3 has a hidden password option.
Key Benefits of VTP Version 3
Much work has gone into improving the usability of VTP version 3 in three major areas:
The new version of VTP offers better administrative control over which device is allowed to update
other devices\’ view of the VLAN topology. The chance of unintended and disruptive changes is
significantly reduced, and availability is increased. The reduced risk of unintended changes will
ease the change process and help speed deployment.
Functionality for the VLAN environment has been significantly expanded. Two enhancements are
most beneficial for today\’s networks:
Refer to the exhibit.
Which statement is correct about the prefix 22.214.171.124/8?
A. The prefix has encountered a routing loop.
B. The prefix is an aggregate with an as-set.
C. The prefix has been aggregated twice, once in AS 100 and once in AS 200.
D. None of these statements is true.
Refer to the exhibit.
Which path is selected as best path?
A. path 1, because it is learned from IGP B.
path 1, because the metric is the lowest C.
path 2, because it is external
D. path 2, because it has the higher router ID
Refer to the exhibit.
After a link flap in the network, which two EIGRP neighbors will not be queried for alternative
paths? (Choose two.)
Both 192.168.3.7 and 192.168.3.8 are in an EIGRP Stub area
The Enhanced Interior Gateway Routing Protocol (EIGRP) Stub Routing feature improves network
stability, reduces resource utilization, and simplifies stub router configuration.
Stub routing is commonly used in a hub and spoke network topology. In a hub and spoke network,
one or more end (stub) networks are connected to a remote router (the spoke) that is connected to
one or more distribution routers (the hub). The remote router is adjacent only to one or more
distribution routers. The only route for IP traffic to follow into the remote router is through a
distribution router. This type of configuration is commonly used in WAN topologies where the
distribution router is directly connected to a WAN. The distribution router can be connected to
many more remote routers. Often, the distribution router will be connected to 100 or more remote
routers. In a hub and spoke topology, the remote router must forward all nonlocal traffic to a
distribution router, so it becomes unnecessary for the remote router to hold a complete routing
table. Generally, the distribution router need not send anything more than a default route to the
When using the EIGRP Stub Routing feature, you need to configure the distribution and remote
routers to use EIGRP, and to configure only the remote router as a stub. Only specified routes are
propagated from the remote (stub) router. The router responds to queries for summaries,
connected routes, redistributed static routes, external routes, and internal routes with the message
“inaccessible.” A router that is configured as a stub will send a special peer information packet to
all neighboring routers to report its status as a stub router. Any neighbor that receives a packet
informing it of the stub status will not query the stub router for any routes, and a router that has a
stub peer will not query that peer. The stub router will depend on the distribution router to send the
proper updates to all peers.
Refer to the exhibit.
Why is AS 65333 in parentheses?
A. It is an external AS.
B. It is a confederation AS.
C. It is the AS of a route reflector.
D. It is our own AS.
E. A route map has been applied to this route.
F. The BGP next hop is unreachable.
What is the flooding scope of an OSPFv3 LSA, if the value of the S2 bit is set to 1 and the S1 bit is
set to 0?
A. link local
B. area wide
C. AS wide
The Type 1 router LSA is now link local and the Type 2 Network LSA is AS Wide
S2 and S1 indicate the LSA\’s flooding scope. Table 9-1 shows the possible values of these two
bits and the associated flooding scopes.
Table 9-1 S bits in the OSPFv3 LSA Link State Type field and their associated flooding scopes
LSA Function Code, the last 13 bits of the LS Type field, corresponds to the OSPFv2 Type field.
Table 9-2 shows the common LSA types used by OSPFv3 and the values of their corresponding
LS Types. If you decode the hex values, you will see that the default U bit of all of them is 0. The S
bits of all LSAs except two indicate area scope. Of the remaining two, AS External LSAs have an
AS flooding scope and Link LSAs have a linklocal flooding scope. Most of the OSPFv3 LSAs have
functional counterparts in OSPFv2; these OSPFv2 LSAs and their types are also shown in Table
Table 9-2 OSPFv3 LSA types and their OSPFv2 counterparts
Which two OSPF LSA types are new in OSPF version 3? (Choose two.)
B. NSSA external
C. Network link
D. Intra-area prefix
E. AS domain
New LSA Types
OSPFv3 carries over the seven basic LSA types we\’re familiar with from OSPFv2. However, the
type 1 and 2 LSAs have been re-purposed, as will be discussed in a bit. OSPFv3 also introduces
two new LSA types: Link and Intra-area Prefix.
CertBus exam braindumps are pass guaranteed. We guarantee your pass for the 400-101 exam successfully with our Cisco materials. CertBus CCIE Routing and Switching Written v5.0 exam PDF and VCE are the latest and most accurate. We have the best Cisco in our team to make sure CertBus CCIE Routing and Switching Written v5.0 exam questions and answers are the most valid. CertBus exam CCIE Routing and Switching Written v5.0 exam dumps will help you to be the Cisco specialist, clear your 400-101 exam and get the final success.
400-101 Latest questions and answers on Google Drive(100% Free Download): https://drive.google.com/file/d/0B_3QX8HGRR1mdEpkTFZvSDJDc2c/view?usp=sharing
400-101 Cisco exam dumps (100% Pass Guaranteed) from CertBus: https://www.certgod.com/400-101.html [100% Exam Pass Guaranteed]
Why select/choose CertBus?
Millions of interested professionals can touch the destination of success in exams by certgod.com. products which would be available, affordable, updated and of really best quality to overcome the difficulties of any course outlines. Questions and Answers material is updated in highly outclass manner on regular basis and material is released periodically and is available in testing centers with whom we are maintaining our relationship to get latest material.