CertBus 2018 Valid Cisco 400-101 CCIE Exam VCE and PDF Dumps for Free Download!
☆ 400-101 CCIE Exam PDF and VCE Dumps : 1063QAs Instant Download: https://www.certbus.com/400-101.html [100% 400-101 Exam Pass Guaranteed or Money Refund!!]
☆ Free view online pdf on CertBus free test 400-101 PDF: https://www.certbus.com/online-pdf/400-101.pdf
☆ CertBus 2018 Valid 400-101 CCIE exam Question PDF Free Download from Google Drive Share: https://drive.google.com/file/d/0B_3QX8HGRR1mdEpkTFZvSDJDc2c/view?usp=sharing
Following 400-101 1063QAs are all new published by Cisco Official Exam Center
As a leading IT exam study material provider, CertBus not only provides you the Latest 400-101 pdf exam questions and answers but also the most comprehensive knowledge of the whole CCIE Newest 400-101 pdf CCIE Routing and Switching Written v5.0 certifications. We provide our users with the most accurate May 31,2018 Latest 400-101 vce CCIE Routing and Switching Written v5.0 study material about the CCIE Latest 400-101 vce dumps exam and the guarantee of pass. We assist you to get well prepared for CCIE Newest 400-101 vce dumps certification which is regarded valuable the IT sector.
CertBus- being successful in your 400-101 certification exams with 400-101 exam study guide. 100% pass rate and money back guarantee. CertBus: 400-101 certification training portal. CertBus exam guide: pass the 400-101 exam on your first attempt! CertBus – your reliable partner and professional 400-101 certification exam material provider.
We CertBus has our own expert team. They selected and published the latest 400-101 preparation materials from Cisco Official Exam-Center: https://www.certbus.com/400-101.html
QUESTION NO:1
Which two commands are required to enable multicast on a router, knowing that the receivers only
support IGMPv2? (Choose two.)
A. ip pim rp-address
B. ip pim ssm
C. ip pim sparse-mode
D. ip pim passive
Answer: A,C
Explanation:
Sparse mode logic (pull mode) is the opposite of Dense mode logic (push mode), in Dense mode
it is supposed that in every network there is someone who is requesting the multicast traffic so
PIM-DM routers begin by flooding the multicast traffic out of all their interfaces except those from
where a prune message is received to eliminate the
QUESTION NO:2
A branch router is configured with an egress QoS policy that was designed for a total number of
10 concurrent VOIP calls.
Due to expansion, 15 VOIP calls are now running over the link, but after the 14th call was
established, all calls were affected and the voice quality was dramatically degraded.
Assuming that there is enough bandwidth on the link for all of this traffic, which part of the QoS
configuration should be updated due to the new traffic profile?
A. Increase the shaping rate for the priority queue. B.
Remove the policer applied on the priority queue. C.
Remove the shaper applied on the priority queue. D.
Increase the policing rate for the priority queue.
Answer: D
Explanation:
QUESTION NO:3
A new backup connection is being deployed on a remote site router. The stability of the connection
has been a concern. In order to provide more information to EIGRP regarding this interface, you
wish to incorporate the “reliability” cost metric in the EIGRP calculation with the command metric
weights 1 0 1 0 1.
What impact will this modification on the remote site router have for other existing EIGRP
neighborships from the same EIGRP domain?
A. Existing neighbors will immediately begin using the new metric.
B. Existing neighbors will use the new metric after clearing the EIGRP neighbors.
C. Existing neighbors will resync, maintaining the neighbor relationship.
D. All existing neighbor relationships will go down.
Answer: D
Explanation:
QUESTION NO:13
Which two statements are true about traffic shaping? (Choose two.)
A. Out-of-profile packets are queued.
B. It causes TCP retransmits.
C. Marking/remarking is not supported.
D. It does not respond to BECN and ForeSight Messages.
E. It uses a single/two-bucket mechanism for metering.
Answer: A,C
Explanation:
QUESTION NO:14
Which three options are features of VTP version 3? (Choose three.)
A. VTPv3 supports 8K VLANs.
B. VTPv3 supports private VLAN mapping.
C. VTPv3 allows for domain discovery.
D. VTPv3 uses a primary server concept to avoid configuration revision issues.
E. VTPv3 is not compatible with VTPv1 or VTPv2.
F. VTPv3 has a hidden password option.
Answer: B,D,F
Explanation:
Key Benefits of VTP Version 3
Much work has gone into improving the usability of VTP version 3 in three major areas:
The new version of VTP offers better administrative control over which device is allowed to update
other devices\’ view of the VLAN topology. The chance of unintended and disruptive changes is
significantly reduced, and availability is increased. The reduced risk of unintended changes will
ease the change process and help speed deployment.
Functionality for the VLAN environment has been significantly expanded. Two enhancements are
most beneficial for today\’s networks:
400-101 PDF Dumps400-101 Exam Questions400-101 Braindumps
QUESTION NO:16
In 802.1s, how is the VLAN to instance mapping represented in the BPDU?
A. The VLAN to instance mapping is a normal 16-byte field in the MST BPDU.
B. The VLAN to instance mapping is a normal 12-byte field in the MST BPDU.
C. The VLAN to instance mapping is a 16-byte MD5 signature field in the MST BPDU.
D. The VLAN to instance mapping is a 12-byte MD5 signature field in the MST BPDU.
Answer: C
Explanation:
MST Configuration and MST Region
Each switch running MST in the network has a single MST configuration that consists of these
three attributes:
1. An alphanumeric configuration name (32 bytes)
2. A configuration revision number (two bytes)
3. A 4096-element table that associates each of the potential 4096 VLANs supported on the
chassis to a given instance.
In order to be part of a common MST region, a group of switches must share the same
configuration attributes.
It is up to the network administrator to properly propagate the configuration throughout the region.
Currently, this step is only possible by the means of the command line interface (CLI) or through
Simple Network
Management Protocol (SNMP). Other methods can be envisioned, as the IEEE specification does
not explicitly mention how to accomplish that step.
Note: If for any reason two switches differ on one or more configuration attribute, the switches are
part of different regions. For more information refer to the Region Boundary section of this
document.
Region Boundary
In order to ensure consistent VLAN-to-instance mapping, it is necessary for the protocol to be able
to exactly identify the boundaries of the regions. For that purpose, the characteristics of the region
are included in the BPDUs. The exact VLANs-to-instance mapping is not propagated in the BPDU,
because the switches only need to know whether they are in the same region as a neighbor.
Therefore, only a digest of the VLANs-toinstance mapping table is sent, along with the revision
number and the name. Once a switch receives a BPDU, the switch extracts the digest (a
numerical value derived from the VLAN-to-instance mapping table through a mathematical
function) and compares this digest with its own computed digest. If the digests differ, the port on
which the BPDU was received is at the boundary of a region.
In generic terms, a port is at the boundary of a region if the designated bridge on its segment is in
a different region or if it receives legacy 802.1d BPDUs. In this diagram, the port on B1 is at the
boundary of region A, whereas the ports on B2 and B3 are internal to region B:
MST Instances
According to the IEEE 802.1s specification, an MST bridge must be able to handle at least these
two instances:
One Internal Spanning Tree (IST)
One or more Multiple Spanning Tree Instance(s) (MSTIs)
The terminology continues to evolve, as 802.1s is actually in a pre-standard phase. It is likely
these names will change in the final release of 802.1s. The Cisco implementation supports 16
instances: one IST (instance 0) and 15 MSTIs.
show vtp status
Cisco switches “show vtp status” Field Descriptions has a MD5 digest field that is a 16-byte
checksum of the
VTP configuration as shown below
Router# show vtp status
VTP Version: 3 (capable)
Configuration Revision: 1
Maximum VLANs supported locally: 1005
Number of existing VLANs: 37
VTP Operating Mode: Server
VTP Domain Name: [smartports]
VTP Pruning Mode: Disabled
VTP V2 Mode: Enabled
VTP Traps Generation: Disabled
MD5 digest : 0x26 0xEE 0x0D 0x84 0x73 0x0E 0x1B 0x69
Configuration last modified by 172.20.52.19 at 7-25-08 14:33:43
Local updater ID is 172.20.52.19 on interface Gi5/2 (first layer3 interface fou)
VTP version running: 2
Reference
http://www.cisco.com/en/US/tech/tk389/tk621/technologies_white_paper09186a0080094cfc.shtml
http://www.cisco.com/en/US/docs/ios-xml/ios/lanswitch/command/lsw-cr-book.pdf
QUESTION NO:20
Refer to the exhibit.
What is the potential issue with this configuration?
A. There is no potential issue; OSPF will work fine in any condition.
B. Sub-optimal routing may occur since there is no area 1 adjacency between the ABRs.
C. This is a wrong OSPF configuration because all routers must be in area 0 only.
D. This is a wrong OSPF configuration because /30 requires 0.0.0.3 wild card.
Answer: B
Explanation:
QUESTION NO:22
Refer to the exhibit.
Which path is selected as best path?
A. path 1, because it is learned from IGP B.
path 1, because the metric is the lowest C.
path 2, because it is external
D. path 2, because it has the higher router ID
Answer: B
Explanation:
QUESTION NO:24
Refer to the exhibit.
R1 is not learning about the 172.16.10.0 subnet from the BGP neighbor R2 (209.165.202.130).
What can be done so that R1 will learn about this network?
A. Disable auto-summary on R2.
B. Configure an explicit network command for the 172.16.10.0 subnet on R2.
C. Subnet information cannot be passed between IBGP peers.
D. Disable auto-summary on R1.
Answer: B
Explanation:
By default, BGP does not accept subnets redistributed from IGP. To advertise and carry subnet
routes in BGP, use an explicit network command or the no auto-summary command. If you disable
auto-summarization and have not entered a network command, you will not advertise network
routes for networks with subnet routes unless they contain a summary route.
Reference
http://www.cisco.com/en/US/docs/ios/11_3/np1/command/reference/1rbgp.html
QUESTION NO:26
Refer to the exhibit.
Why is AS 65333 in parentheses?
A. It is an external AS.
B. It is a confederation AS.
C. It is the AS of a route reflector.
D. It is our own AS.
E. A route map has been applied to this route.
F. The BGP next hop is unreachable.
Answer: B
Explanation:
CertBus exam braindumps are pass guaranteed. We guarantee your pass for the 400-101 exam successfully with our Cisco materials. CertBus CCIE Routing and Switching Written v5.0 exam PDF and VCE are the latest and most accurate. We have the best Cisco in our team to make sure CertBus CCIE Routing and Switching Written v5.0 exam questions and answers are the most valid. CertBus exam CCIE Routing and Switching Written v5.0 exam dumps will help you to be the Cisco specialist, clear your 400-101 exam and get the final success.
400-101 Latest questions and answers on Google Drive(100% Free Download): https://drive.google.com/file/d/0B_3QX8HGRR1mdEpkTFZvSDJDc2c/view?usp=sharing
400-101 Cisco exam dumps (100% Pass Guaranteed) from CertBus: https://www.certbus.com/400-101.html [100% Exam Pass Guaranteed]
Why select/choose CertBus?
Millions of interested professionals can touch the destination of success in exams by certbus.com. products which would be available, affordable, updated and of really best quality to overcome the difficulties of any course outlines. Questions and Answers material is updated in highly outclass manner on regular basis and material is released periodically and is available in testing centers with whom we are maintaining our relationship to get latest material.
 |  |  |  |  | |
|---|---|---|---|---|---|
 |  | | |  | |
| Brand | Certbus | Testking | Pass4sure | Actualtests | Others |
| Price | $45.99 | $124.99 | $125.99 | $189 | $69.99-99.99 |
| Up-to-Date Dumps |  |  | | | |
| Free 365 Days Update | | | | | |
| Real Questions | | | | | |
| Printable PDF | | | | | |
| Test Engine | | | | | |
| One Time Purchase | | | | | |
| Instant Download | | | | | |
| Unlimited Install | | | | | |
| 100% Pass Guarantee | | | | | |
| 100% Money Back | | | | | |
| Secure Payment | | | | | |
| Privacy Protection | | | | | |
